Need Help，All FC3 keys and axis were lost

[raptorcn]

My machine was first installed with FC3 and A10C. But When I installed K50 after, all FC3 keys were lost. It was too bad. restore default value has been proved to be invalid. What should I do?:(:(:(

[farmertom]

My machine was first installed with FC3 and A10C. But When I installed K50 after, all FC3 keys were lost. It was too bad. restore default value has been proved to be invalid. What should I do?:(:(:(

depends on your particular hardware. If you have an X-52 or X-55, try going to controller tab and clear the throttle and stick controller settings. DCS is starting to build default Hotas setting for controllers and it is screwing thing up. A word of advice I would start to learn how to configure your controller for I feel we will be doing this again.

Good luck

[raptorcn]

depends on your particular hardware. If you have an X-52 or X-55, try going to controller tab and clear the throttle and stick controller settings. DCS is starting to build default Hotas setting for controllers and it is screwing thing up. A word of advice I would start to learn how to configure your controller for I feel we will be doing this again.

Good luck

Thank you for your reply, I think it may be that an update has screwed up all the FC3 keys. I am using HotasWarthog and SaitekProFlightRudder. Now all three devices, one throttle, one joystick, one rudder, are all set. The same wrong axis and keys,

like that：

 

Throttle joystick rudder

JOY_Y JOY_Y JOY_Y

JOY_Z JOY_Z

JOY_RZ JOY_RZ JOY_Z

JOY_X JOY_X JOY_X

 

what should i do ？:helpsmilie::helpsmilie::helpsmilie:

 

Or could ED release which update to restore the original default FC3 key, if not I need to reset the axis and key position for all aircraft, its terrible,:cry::cry::cry:

 

I have followed the axis and the key position according to the method you have guided.

 

But, do I have to re set,set,set,set,set,set it again?:(

[farmertom]

I would not wait for DCS to solve your problem. Like I said earlier it would pay for you to learn how to program your controllers. I don't have a warthog.

 

After you delete all of DCS key bindings settings did you save the controller profile? Save all three.(stick, throttle, rudder). There are many HOTAS profiles available. Having a Warthog there should be plenty of help and advice online if you find the correct thread.

Good Luck.

[draconus]

There are default profiles that you can load - especially for the most popular stick. Start from there if you want to change anything.

https://forums.eagle.ru/showpost.php?p=3659742&postcount=5

 

 

If you put a lot of time to set your bindings this is your work. It's saved as files in your \Saved Games\DCS\Input folder. If you value your work and time make a backup of these files!