Auto bomb mode

[pete_auau]

After the last update iam having issues in selecting the auto bomb mode, where as I cant get the bomb line to appear on the hud where as if I select ccip mode I have no issues, Went to the training section followed the auto training mission and followed what was shown there but to no avail

[gabuzomeu]

Did you designate a target? (for example press WPDSG on HSI to designate a waypoint)

[pete_auau]

Did you designate a target? (for example press WPDSG on HSI to designate a waypoint)

 

yes I did I followed everything in the training section in auto bombing mode in the videos I have been looking at as soon as you press the wpdsg you should get the asl line etc in which I dont, it works some times but only if I keep pressing diffrent buttons etc eg the uncage, than un select the air the ground mode but doesn't usually happen in that order like to know what the steps are for getting the asl line up this is the order I been doing

 

 

1 switch arm on

 

select air to ground

select the bombs that I have got change to mode to auto etc fuzes etc

 

Then in the hsi switched to wpt than select the way point number than select wpdsg

 

 

some times when I press the wpdsg I see the asl flash there but it doesn't stay there

 

 

EDIT

 

 

ok got it to work if I do it in the reverse order as list above it works so happy with that now to work out way the laser doesn't hit the target its way off

Edited January 28, 2019 by pete_auau

[macedk]

check height of waypoint, I made that mistake.

 

same goes for A-10, so my waypoint was a 6000 feet so no fall line :)

[pete_auau]

check height of waypoint, I made that mistake.

 

same goes for A-10, so my waypoint was a 6000 feet so no fall line :)

thx for the info