GazAce Posted February 9, 2019 Posted February 9, 2019 (edited) Hi groovy Pilots, I'm just wondering if anyone is having dramas with setting DTOT either using their CDU or UFC? I'm probably doing this incorrectly but when I set the desired time at any specific WP and then when I cycle thru them, all are showing same time. I can't seem to find any docs on this other than the manual pages 470 -471 and yes it explained the method but I'm still getting all the WPs set with same time? I'm a little freaked by this one as not being able to set each WP with a different DTOT. Any buffs out there care to chime in and let me know what I'm doing wrong? Would be much appreciated. Regards G Oops I think I found where I was going wrong, was on the wrong page in CDU Nope, still not getting it. Just watched the Bunyap Sims vid on this and it looked great but I still can't seem to have separate TOTs set for different WPs Edited February 9, 2019 by GazAce GazAce's "Skynet Rig" :: :: 13th Gen Intel Core i9-13900K :: Asus ROG Strix Z790-A Mobo :: Nvidia GeForce RTX 4090 MSI Gaming Slim GPU 24GB :: NZXT Kraken Elite 280 RGB AIO White Cooler :: G Skill Trident Z Royals DDR4 4x16GB = 64GB :: WD Black SN 850X NVMe SSD 2TB M.2 (C Drive) :: Samsung 860 Pro 2TB SATA (D Drive) & a couple of other Drives adding another 1.5 TB :: Corsair Crystal 680X White Case :: Asus XG349C 34" Curve G-Sync 180Hz 3440x1440 Monitor :: MSI 1000 Watt PSU PCIE5 :: Virpil Constellation Alpha-R Stick with VPC WarBRD Base :: Virpil MongoosT-50CM3 Throttle :: 3 x CubeSim ext mini screens with TM Cougar MFD Bezels :: Asus ROG Pugio 503 Gaming Mouse & Razer BlackWidow mech kb :: TrackIR 5 Pro & Cap Clip :: Win 11 64 Bit
LUPO1606688396 Posted June 1, 2020 Posted June 1, 2020 Hi! I see is an old post, but I am experiencing the same problem. It seems that I cannot set the DTOT. Did you find a solution? Thanks a lot! [sIGPIC][/sIGPIC]
Stuka Posted June 3, 2020 Posted June 3, 2020 You can set a TOT for every WP in the CDU. The HUD will only show the required speed if a steerpoint with a set TOT is selected. Windows 11 | i9 12900KF | 64GB DDR4 | RTX 3090 | TM Warthog HOTAS | Saitek Combat Rudder Pedals | TM MFDs + Lilliput 8" | TIR5 Pro
LUPO1606688396 Posted June 6, 2020 Posted June 6, 2020 You can set a TOT for every WP in the CDU. The HUD will only show the required speed if a steerpoint with a set TOT is selected. Thanks Stuka, I finally was able to figure it out! Had problem specially when setting for an offset location. But now it's clear. Greets from Italy! :pilotfly: [sIGPIC][/sIGPIC]
Recommended Posts