As soon as I added the Mig19p

[71st_Mastiff]

as soon as I go to the controls for the Mig19p, and axis and try to set up the Wheel break, the inputs stop working. Virpil T50 Mongoose.

 

All my inputs and key bindings no longer work. for any modules.. I have to exit the sim and reboot then everything is working again until I go to the mig 19p control then it stops working.

Edited March 6, 2019 by Mastiff

[sze5003]

It happens when you try to bind the axis of the mig19 first. Exit DCS and come back int, they should be working at that point.

[71st_Mastiff]

It happens when you try to bind the axis of the mig19 first. Exit DCS and come back int, they should be working at that point.

 

nope stops responding every time I access the Mig19p

[sze5003]

nope stops responding every time I access the Mig19p

Try exiting, go back in but set up the axis commands last for the mig 19. Make sure you hit ok after you set the other commands or else they may not save if you go to the axis section after.

[71st_Mastiff]

Try exiting, go back in but set up the axis commands last for the mig 19. Make sure you hit ok after you set the other commands or else they may not save if you go to the axis section after.

 

if I don't access the mig 19p controls all is working,

 

As soon as I go into the Mig19p controls setting it freezes.

[sze5003]

Hmm try a dcs repair then clean up. I haven't installed the latest dcs update so I will check when I get home.

 

But go to your dcs install directory inside the bin folder. Hold shift right click, open shell window here. Type "dcs_updater.exe repair" without quotes.

 

Then when it's done do the same replace repair with cleanup.

 

Other than that I would consider uninstalling and reinstalling the module.

[AJaromir]

Please, IMO one thread is enough:

https://forums.eagle.ru/showthread.php?t=233656