JUICE-AWG Posted June 6, 2019 Posted June 6, 2019 (edited) Hi, I searched through the forums and didn't find a post on this yet, but there is a problem with the F18 Maverick mission (Nevada version) where the JTAC is close to the targets he's controlling you onto but he isn't set as invisible so very soon after your initial check-in, he gets destroyed by the enemy vehicles he's trying to target for you. Simple fix, under advanced (waypoint actions) set a perform command to "invisible" and all is good! To follow up my report, I manually edited the mission and at first it didn't protect the JTAC asset until I moved invisible up to the top (#1) spot on the actions list. Cheers, Edited June 6, 2019 by =JUICE= Shortening the title "There are only two types of aircraft, Fighters and Targets." Doyle "Wahoo" Nicholson [sIGPIC][/sIGPIC]
Razi Posted June 7, 2019 Posted June 7, 2019 (edited) I've been trying to fix this mission as well doing the same thing, but for some reason DCS freezes when I load it. All I have done is added an ROE option to hold weapons and perform invisible command as options 2 and 3 which has worked for me when I create missions with JTAC. Not sure what is going on with this mission. Edit: Actually I think the op is referring to a different mission perhaps. I've been trying to fix the one with the filename "Nevada FA-18C Maverick Practice.miz" Edit 2: The freezing has something to do with the default High graphics settings. Works on Low settings. So far only this missions does this for me. Edited June 7, 2019 by Razi
JUICE-AWG Posted June 11, 2019 Author Posted June 11, 2019 I had to move the Invisible to #1 in waypoint actions but something just started tonight with the Iron Hand Red Flag mission. It will not finish loading in Single Player or the Edited MP mission for 2 people I adapted from it. Just started tonight...and I've run Repair DCS and tried it again with the same results. Mine worked fine before today...with no changes to my settings. "There are only two types of aircraft, Fighters and Targets." Doyle "Wahoo" Nicholson [sIGPIC][/sIGPIC]
Eviscerador Posted July 5, 2019 Posted July 5, 2019 Aside from that small detail (which by the way is still not fixed) the JTAC only gives you laser mark for one target and then switches off. You have 4 Mavs, 2 Laser and 2 IR, but you can only launch one laser due to that. Al you have to do is clone the target designate option for another target. [sIGPIC][/sIGPIC]
Recommended Posts