[ATC W.I.P]"Hold position" Failure to Launch

[Habu_69]

DCSW OB 2.5.5.35461. 2-ship cold start from Stennis parking slot. After start-up pilot taxis to cat 3, -2 taxis to cat 2. Immediately on taxiing tower continuously repeats nag to "hold position." When in position on cat 3 pilot must wait a few seconds after -2 launches or he never gets permission to launch. Requesting permission too quickly, "U" key, ticks off the tower and permission never comes, despite repeating launch sequence. Impossible to launch. Track attached.

Failure to Launch.rar

[BIGNEWY]

Hi

 

I am unable to check the track due to the unofficial mods installed.

 

Can you reproduce with a clean client?

[Habu_69]

Clean mission, same behavior. PG theater. Flying VR. Track attached.

Launch Test.trk

[BIGNEWY]

Thanks for the quick reply and track.

 

It looks to me when I watch it back you are going to far forward for the cat.

 

You should get as close to the cat with the front wheel as possible put the bar down and the press U to connect, the blast deflector will pop up behind you and you will see steam in the track.

[BIGNEWY]

Just tested and all seems ok for me.

[Habu_69]

OK. Uninstalled all mods, did repair, more testing. Still get the "hold position" nag. Do finally get launch permission, but only after several "U" requests. Still some bug, I think, but at least it is workable. Another track attached. TY for your troubleshooting.

Launch Test 3.trk

[BIGNEWY]

The ATC is being worked on so don't focus on the radio to much.

 

As long as you are able to connect and launch correctly at the moment.