Keystrokes are sometimes not accepted

[bavella1]

Relatively often I have the problem that some (different) keystrokes of my HOTAS Warthog will only be accepted after I pressed the button several times. This is the case, for example, with the Sensor Control Switch or also with the RAID/FLIR/FOV (and others) and does not seem to have a definite cause. With two multi-player colleagues, it seems to be similar now and then.

 

Is this problem well known or are there only a few Simmers affected?

Are there ways to remedy this?

 

I attach my Warthog profile once here for information.

 

Thank you in advance and best regards!

bavella_Hornet_sc_2.zip

[Vatikus]

Set SetKBRate higher... I have seen you are using TEMPO command and 32ms pulse is too short for DCS to register keystroke. I am using 200ms and I do not have problems anymore.

[Pikey]

I've avoided software as a middleware for all hotas and use them direct just fine in DCS. That doesnt stop WH's acting up though, they can report a range of issues. But it does cut out issues with the software.

[bavella1]

Corrected:

- SetKBRate(60, 70);

- Sensor Select forward/aft/left/right set to DX-Buttons (without PULSE+)

 

Much better now, but it still needed some double keystrokes.

 

Thx for the support!

[Tom Kazansky]

I have a similar problem with a 2nd keyboard. A kind of a button box.

 

 

what/where is this SetKBRate() command?

 

 

is it a warthog only thing?

[bavella1]

what/where is this SetKBRate() command?

 

 

is it a warthog only thing?

 

Yes, it is set in the *.tmc Profil-File.

 

Not sure if my problem is solved at all as I now remember that it was a bigger problem in multiplayer-sessions and today I was only trying in singleplayer. I´ll see...

[Tom Kazansky]

Ok. Thanks