Bullseye Display in RDR MFD

[bonesvf103]

So I was brushing up on things in the Hornet and I was watching Wags' video on AA Waypoints and bullseye. In it, in the RDR MFD, you have at the top left of the MFD, the position of the cursor from the bullseye. In the bottom of the MFD you have your position from the bullseye, and in the bottom left you have BRA from the cursor to you.

 

 

When I try it in the sim, I don't get any of these positions displayed in the MFD. I might get BRA from cursor to me, but nothing else. I tried it in RWS and in TWS, in AA mode and not. But no dice. I checked to make sure the mission had a bullseye and it did show one on the F10 map.

 

 

Is it that even though there is a bullseye on the map, I still have to make sure there is an AA waypoint assigned to it? Or it its present on the map mean it's already programmed into the Hornet's nav?

 

 

Or am I missing something else?

 

 

Thanks!

 

 

 

v6,

boNes

[Fisherman82]

Set a waypoint on the same place as the bullseye. Then in the cockpit pick that waypoint on the HSI and go to DATA submeny, there set it as A/A Waypoint on the left side.

 

Skickat från min D5503 via Tapatalk

[bonesvf103]

OK, so then my suspicions are correct...I have to set bullseye as an AA waypoint even though it's already on the map/in the mission.

 

 

Too bad if there is a bullseye in the mission it's not automatically set in the Hornet...but I guess that's what data cartridges are for which I don't think is modeled in the DCS Hornet yet.

 

 

Thanks.

 

 

 

v6,

boNes