Jump to content

Recommended Posts

Posted

hi all.

 

Im trying to launch a colour flare to mark enemies but I dont know how to do it. Can you help me . I have searched in internet, videos, manual...

 

Thanks.

Posted

The coloured signal flares are fired using these buttons on the rear end of the right hand console: (edit: the colour-coded ones marked 1, 2, 3 and 4 in the center of the picture)

Screen-200519-155828.png

Flip the switch to 'On', then just press the button corresponding to the colour you want.

 

Be aware, though, that you only have one flare of each colour and it's basically just dropped from your helicopter, it doesn't get shot anywhere. So to mark a target with it, you - well - have to fly over your target, which is probably not the best way of doing it.

 

If you mark the target for a fellow Ka-50, consider using the datalink. If you are marking for someone else, like a strike airplane, a better way might be to use a smoke rocket.

  • Like 1
Posted

Thank you so much. I want to use in case of find out enemies below but I never fly too close to them. Its very usefull to mark towns, infantery, or places to other planes.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...