Radar elevation Wheel

[VirusAM]

Hi guys i have issues with the radar elevation wheel on the throttle.

In the Hornet i have it bound in the axis section, but when using the FLIR, it acts as if the center would be 100% of the axis, and also if i move the wheel then when i leave it the zoom come back to its initial (wrong) value.

In the AA radar i have not this issue and the radar wheel works as intended (as a relative axis).

Is someone else having the same issue?

 

Also is there a way to set that axis as a relative one for every plane (for example for the F16).

 

Thanks

[Supmua]

I have similar problem with non-Hornet planes, so right now I just use DX button input mode instead of axis for the wheel. In the Hornet if you set a deadzone on that axis, the zoom will stick.

[VirusAM]

I have similar problem with non-Hornet planes, so right now I just use DX button input mode instead of axis for the wheel. In the Hornet if you set a deadzone on that axis, the zoom will stick.

 

 

 

So for you the axis work as intended both in aa radar and when using the TGP?

I just bound it as an axis in dcs settings for the Hornet..I didn’t change anything.

 

As I wrote in my first post i am having issues only when i select the flir...in the AA radar page the antenna works as intended

 

How to use the axis as DX button input mode?

I will need this for sure also for other planes.

[Supmua]

So for you the axis work as intended both in aa radar and when using the TGP?

I just bound it as an axis in dcs settings for the Hornet..I didn’t change anything.

 

As I wrote in my first post i am having issues only when i select the flir...in the AA radar page the antenna works as intended

 

How to use the axis as DX button input mode?

I will need this for sure also for other planes.

 

Axis mode works fine with the Hornet as long as you set a center deadzone around 10-15%. I prefer DX button mode for wide compatibility with other planes. To do this you need to run SimAppPro once and change the behavior from there. It's pretty intuitive and requires a mouse click on the throttle grip diagram.

 

I'm using it as nozzle input for the Harrier. I still suck at vertical landing, but I'm a little better with this throttle compared to the warthog.

Edited June 8, 2020 by Supmua

[VirusAM]

Axis mode works fine with the Hornet as long as you set a center deadzone around 10-15%. I prefer DX button mode for wide compatibility with other planes. To do this you need to run SimAppPro once and change the behavior from there. It's pretty intuitive and requires a mouse click on the throttle grip diagram.

 

I'm using it as nozzle input for the Harrier. I still suck at vertical landing, but I'm a little better with this throttle compared to the warthog.

 

Ok thanks....i didn't know that it is possible to change in Simappro...

I think in the box there was not a manual for it...

So who knows how many things we have yet to discover about this unit.

Maybe also the idle detent can be set differently in some way.

 

So if it works for you I don't understand how it doesn't work for me with the hornet tgp, but works well for the radar. Misteries of '0 and 1s.

Anyway i think your suggestion will be the better one...so will do that.

Thanks