[REPORTED]Ah-64D Accuracy Issues

[stormrider]

Apache engagements lacks in accuracy. Several hellfire launches misses their targets about 10 meters too far causing the Apaches to have to re-engage. Some hellfires are launched too high causing them to complete miss their target or self-destroy. Rockets are currently completely useless. When they run out of Hellfires, they make several passes over the targets, most of the time not even engaging targets, just flying over and over again.

 

 

 

1- Mission 1 is set with 2x AH-64D Tasked with CAS, armed with a mix of 8x Hellfires and 2 Rockets pods each and flying at 98ft and 90knots against a Platoon of T-72 (3x) at ~6nm away.

 

 

Settings: Standard CAS.

 

Result: At some point, the Apaches make contact, start hover, increase altitude and about 10 minutes later engage the tanks with Hellfire.

 

 

1.1- Settings: Added at the initial turnpoint: Perform Task > Attack Group > Selected Group to be attack.

Result: As soon as mission starts, the Apaches fly a direct course towards the tanks and eventually as expected engage with Hellfires.

 

 

1.2- Settings: Added to the inital turnpoint: Start Enroute Task > Search and Engage.

Result: At some point, the Apaches make contact, start hover, increase altitude and sometime later engage the tanks with Hellfire.

 

 

2- Mission 2 is with the same setup as Mission 1, but the tanks were replaced by a SA-2 Battery.

 

 

Settings: Standard CAS.

Result: At some point, the Apaches make contact, start hover, increase altitude and start engaging with Hellfires. For some reason, most hellfires misses the targets by about 10 meters too far. which causes them to re-engage the targets several times.

 

 

2.1- Settings: Added at the initial turnpoint: Perform Task > Attack Group > Selected Group to be attack.

Result: As soon as mission starts, the Apaches fly a direct course towards the tanks and eventually as expected engage with Hellfires. For some reason, most hellfires misses the targets by about 10 meters too far which causes them to re-engage the targets several times. Rockets misses the targets completely.

 

 

 

2.2- Settings: Added to the inital turnpoint: Start Enroute Task > Search and Engage.

Result: At some point, the Apaches make contact, start hover, increase altitude and sometime later engage with Hellfire. For some reason, most hellfires misses the targets by about 10 meters too far which causes them to re-engage the targets several times. Rockets misses the targets completely.

attack_helo_1.miz

attack_helo_1-1.miz

attack_helo_2.miz

attack_helo_2-2.miz

[BIGNEWY]

Reported

 

thanks