"Y Axis" Ptich undetected.

[Ala12Rv-Tundra]

Hi there,

I haven´t used DCS for a week. Today I wanted to fly a A-10C Red Flag mission but apparently I have no "Y Axis" Pitch input.

DCS doesn´t detect the axis.

Windows calibration device tool doesn´t detect the axis.

VPC software calibration tool doesn´t detect the axis.

"X Axis" for roll is fine.

 

My base is former Mongoose. Not an issue since I bought it by December 2018.

[HC_Official]

well the warranty is long gone, nothing stopping you opening it up and checking cables are attached and nothing loose

Edited August 8, 2020 by HC_Official

[Ala12Rv-Tundra]

well the warranty is long gone, nothing stopping youopen ing it up and checking cables are attached and nothing loose

Never opened so I´m going to check your tutorials :thumbup:

[Ala12Rv-Tundra]

Apparently it looks good and all conectors well plugged.

[Ala12Rv-Tundra]

Solved. I did nothing but removing the main USB connector, and press a bit the two connectors from the Y axis.

Plugged it again and thankfully both axis are recognized now.

Thanks.

[HC_Official]

you were not fiddling with internal cables while it was still plugged into USB ?

[Ala12Rv-Tundra]

you were not fiddling with internal cables while it was still plugged into USB ?

I unplugged the base, the remove the bolts which attach it to the desk mount and then the ones from the base itself.