Steve Gee Posted August 12, 2020 Posted August 12, 2020 Before, if you used the commands to raise or lower flaps, they would stop at the Half selection on their movements up or down. Now, if I hit either, it just skips Half and goes to either Auto or Full. "These are NOT 1 to 1 replicas of the real aircraft, there are countless compromises made on each of them" - Senior ED Member Modules - Damn near all of them (no Christian Eagle or Yak) System - Ryzen 9 7900X, 64Gig DDR5 RAM, RTX-4090, 3 32" monitors @1440, default settings of High (plus some)
LeCuvier Posted August 13, 2020 Posted August 13, 2020 I use the 3-position flaps switch on my TM WH throttle with the "Special for Jostick" commands. But, to reproduce your problem, I have bound the "FLAP Switch - Up" and "FLAP Switch - Down" commands to pushbuttons and tested. On my system this works fine, the switch stops in the middle position, so I have to push the "Down" button twice to go from Auto to Full. This is in OB, current update. I cannot imagine why this wouldn't work on your rig. Maybe you should run a Repair. LeCuvier Windows 10 Pro 64Bit | i7-4790 CPU |16 GB RAM|SSD System Disk|SSD Gaming Disk| MSI GTX-1080 Gaming 8 GB| Acer XB270HU | TM Warthog HOTAS | VKB Gladiator Pro | MongoosT-50 | MFG Crosswind Pedals | TrackIR 5
Steve Gee Posted August 13, 2020 Author Posted August 13, 2020 My bad, seems to be something external causing to skip that middle step, keystrokes work as intended. Thanks. "These are NOT 1 to 1 replicas of the real aircraft, there are countless compromises made on each of them" - Senior ED Member Modules - Damn near all of them (no Christian Eagle or Yak) System - Ryzen 9 7900X, 64Gig DDR5 RAM, RTX-4090, 3 32" monitors @1440, default settings of High (plus some)
Recommended Posts