silent one Posted September 20, 2020 Posted September 20, 2020 Im new to the module. Ive been flying hornets with no problem but for some reason Tomcat wont launch. When I salute. They register this . But no launch. I just sit there. Any ideas?
S D Posted September 20, 2020 Posted September 20, 2020 You still have to use the key combo for the Tomcat i believe. Shift-U
Oban Posted September 20, 2020 Posted September 20, 2020 I have had the same issue, especially after "trapping". I think it's down to not using the correct communications throughout the recovery onto the boat. I have tried using the "request launch" and go Mil Power, and then use the "salute" in the comms menu, and the same thing, nothing.. tried full afterburner, no joy. I think Jester needs to switch frequencies to request "take off" It's the only thing I can think of that's stopping the launch ? AMD Ryzen 9 7845HX with Radeon Graphics 3.00 GHz 32 GB RAM 2 TB SSD RTX 4070 8GB Windows 11 64 bit
Raisuli Posted September 20, 2020 Posted September 20, 2020 I have had the same issue, especially after "trapping". I think it's down to not using the correct communications throughout the recovery onto the boat. I have tried using the "request launch" and go Mil Power, and then use the "salute" in the comms menu, and the same thing, nothing.. tried full afterburner, no joy. I think Jester needs to switch frequencies to request "take off" It's the only thing I can think of that's stopping the launch ? Today the crew refused to hook me up. Did a case III+I landing without the trivial steps of actually getting permission, or doing it right. Refueled for a trip to the beach, and all I got in the comms menu was "parent menu" and "Exit". No request to startup or anything. Pulled up to the cat. Nothing. Crew completely ignored me. I was light enough to get off the boat from the cat anyway, but it was kind of annoying not being able to reset the ATC menu. I see that at Ramat David a fair amount, also.
Recommended Posts