Tiger-II Posted December 31, 2020 Posted December 31, 2020 (edited) I have the RADAR elevation assigned to an axis, but it just permanently slews to the limit? I'm pretty sure this is not a n00b mistake. I even cleared the axis assignment and re-set it, but this failed to work. I also have a couple of HOTAS buttons showing permanent RED ! (exclamation) even though the key binds are not duplicated. Clearing these does NOT clear the exclamation point, and these functions do not work (they specifically relate to S5 which apparently were re-worked recently). It might be that my key binds are somehow broken. I have not tested since roughly Dec 15th, so it could be fixed in a later patch, but this was what I found so far. Any suggestions welcome! Edited December 31, 2020 by Tiger-II Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
Blinky.ben Posted December 31, 2020 Posted December 31, 2020 The red symbols are a fairly new key binding combo thing. I haven’t played around with the combo thing myself but it hasn’t caused any issue. But that’s a ED all aircraft thing not a JF thing. also in you axis controls look closely cause there is a fairly new binding for similar thing with antenna tilt. You may need to use the other binding. Many of us missed it when it came out
uboats Posted December 31, 2020 Posted December 31, 2020 if you see RED mark, then you might need to somehow clean/reset binding, or you can manually edit the joystick binding config under saved game. there's no axis binding change since Oct. 1 [sIGPIC][/sIGPIC] My DCS Mods, Skins, Utilities and Scripts | Windows 10 | i7-4790K | GTX 980Ti Hybrid | 32GB RAM | 3TB SSD | | TM Warthog Stick | CH Pro Throttle + Pro Pedal | TIR5 Pro | TM MFD Cougar | Gun Camera: PrtScn |
Tiger-II Posted January 1, 2021 Author Posted January 1, 2021 On 12/31/2020 at 11:45 AM, uboats said: if you see RED mark, then you might need to somehow clean/reset binding, or you can manually edit the joystick binding config under saved game. there's no axis binding change since Oct. OK - I'll try that. On 12/31/2020 at 5:06 AM, Blinky.ben said: The red symbols are a fairly new key binding combo thing. I haven’t played around with the combo thing myself but it hasn’t caused any issue. But that’s a ED all aircraft thing not a JF thing. also in you axis controls look closely cause there is a fairly new binding for similar thing with antenna tilt. You may need to use the other binding. Many of us missed it when it came out I saw the new axis and tried it just in case, but no difference. I'll try it again. Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
unknown Posted January 2, 2021 Posted January 2, 2021 This will probably not help you, but it works for me fine. If i use the axis with the slide function: - 1/3 of axis movement up/down from default middle position -> 1/3 of radar elevation movement up/down in game If i use the axis without the slide function: - radar elevation movement up/down is very slow even if i use max RL axis deflection - radar elevation in game is only moving up/down as long as the axis is out of the default middle position -> no total position mapping like with the slide function but a speed adjusting for up/down movement English is not my native language and i probably didn't explain it well what i meant so here is a YT video showing both axis at work(should be 1440p after YT processing): 1 Modules: KA-50, A-10C, FC3, UH-1H, MI-8MTV2, CA, MIG-21bis, FW-190D9, Bf-109K4, F-86F, MIG-15bis, M-2000C, SA342 Gazelle, AJS-37 Viggen, F/A-18C, F-14, C-101, FW-190A8, F-16C, F-5E, JF-17, SC, Mi-24P Hind, AH-64D Apache, Mirage F1, F-4E Phantom II System: Win 11 Pro 64bit, Ryzen 3800X, 32gb RAM DDR4-3200, PowerColor Radeon RX 6900XT Red Devil ,1 x Samsung SSD 970 EVO Plus 2TB NVMe, 2 x Samsung SSD 2TB + 1TB SATA, MFG Crosswind Rudder Pedals - VIRPIL T-50CM and VIRPIL MongoosT-50 Throttle - HP Reverg G2, using only the latest Open Beta, DCS settings
Recommended Posts