[FIXED] SD-10 Can't Track Jamming Target at all ! Multiplayer Only

[Old Sauveur]

Dear Devs, @L0op8ack

 

The SD-10 is currently unable to track any Jamming Targets. The moment the missile is pitbull, missile goes dumb

 

To reproduce just keep jamming ON. The missile will not track regardless of the firing solution. In TWS, STT and maddog.

 

Please find attached tracks and Tacviews

 

Thank you

Best Regards,

TAW_Savior

[TARGET POV] SD-10 can't track jamming targets .trk [SHOOTER POV] SD-10 can't track jamming targets .txt.acmi [SHOOTER POV] SD-10 can't track jamming targets .trk

[uboats]

is the target 22nm away?

[Jonne]

Now that would explain the problems we had with the SD-10 last week. I will try and contribute when at home.

[Old Sauveur]

@uboats no This inside 15 and all the shots even below 8 nm aren't tracking. Completely inside bleedthrough

[uboats]

2 minutes ago, Old Sauveur said:

@uboats no This inside 15 and all the shots even below 8 nm aren't tracking. Completely inside bleedthrough

will check

[Old Sauveur]

@uboats ANY jamming capable plane in DCS can achieve this ! the SD-10 is rendered useless atm

[L0op8ack]

SP is affected too.

seems like SD-10 seeker is not properly activated.

 we are woring on this.

thanks for report.

Edited January 13, 2021 by L0op8ack

[uboats]

we just found the issue:

Normally, if the radar burns through the jam, launching missile should not use HOJ mode but normal one. After burn through, the distance can be measured, then pilot can launch with loft (that's also how we implemented it)

However, in ED's amraam scheme, if the target is jamming, the missile has to use HOJ mode no matter the radar burns through or not.

otherwise, the missile will not track the target.

We've reported this issue to ED.

 

Also, we've made a walk around solution for this.

But we still hope there will be an official enhancement and solution from ED.