Jump to content

How to put the TPOD into snowplow or boresight mode?


Recommended Posts

Posted

Hoping that someone can advise.

I was out practising last night in the Harrier and was really struggling to get the TPOD to reset to a boresight position (i.e. to the front, in the middle of the HUD).

 

Can someone please advise.

7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat 

Posted

Update:  think I've found it.

I found that by putting the TPOD into INS mode (sensor select down twice), then hitting NWS twice seemed to work.

7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat 

Posted (edited)

Doesn't just hitting the Undesignated/NWS button do it as well? I'm just learning the sensors, and the trainings don't seem to be referencing the same items now.

Edited by unlikely_spider
  • Like 2

Modules: Wright Flyer, Spruce Goose, Voyager 1

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...