Nomak Posted February 14, 2021 Posted February 14, 2021 Hello all, im new so don't burn me if this was discussed before, i couldn't find anything. The TDC cursor is moving all around and not locking, in ground or air mode it is constantly slewing itself in a direction and making it very difficult to act quick. Is there a solution, am i doing something wrong?
Mustang25 Posted February 14, 2021 Posted February 14, 2021 How far away from the target are you? It will only ground stabilize at 21 miles if not it will move relative to the aircraft.
Nomak Posted February 14, 2021 Author Posted February 14, 2021 I think i am in the 10 miles radius but its nearly impossible for me to be precise or put it over the target, how are you supposed to do it
dorianR666 Posted February 16, 2021 Posted February 16, 2021 binding issue for sure. if its slewing by itself it means you havent configured a deadzone CPU: AMD Ryzen 5 1600X GPU: AMD RX 580
Tiger-II Posted February 16, 2021 Posted February 16, 2021 On 2/14/2021 at 9:04 PM, Nomak said: I think i am in the 10 miles radius but its nearly impossible for me to be precise or put it over the target, how are you supposed to do it In Special options, reduce the slew rate of the TGP. Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
Recommended Posts