ny3d1 Posted February 22, 2021 Share Posted February 22, 2021 Problem is that when I turn the knob from "Norm" to "Nav" (Avionics Power panel) I am not getting the distance to waypoint and the "tadpole" is pointing straight up. In the past this wasn't happening. Did something change in the last updates?? Link to comment Share on other sites More sharing options...
Solution Eaglewings Posted February 22, 2021 Solution Share Posted February 22, 2021 Ensure if the align process was properly done. One update added some months ago was to ensure that you press enter on the UFC keypad on the first few seconds after turning the NAV knob to ALIGN to register current coordinates of the aircraft.Alternatively, you can do inflight alignment after takeoff. Windows 10 Pro 64bit|Ryzen 5600 @3.8Ghz|EVGA RTX 3070 XC3 Ultra|Corair vengence 32G DDR4 @3200mhz|MSI B550|Thrustmaster Flightstick| Virpil CM3 Throttle| Thrustmaster TFRP Rudder Pedal /Samsung Odyssey Plus Headset Link to comment Share on other sites More sharing options...
Florence201 Posted February 22, 2021 Share Posted February 22, 2021 Watch YT videos on start up. 2 procedures to align the INS. Stored - short alignment based on jets parked INS position. DO NIT accept L/L via ICP Norm - full alignment. Accept L/L on ICP using Enter and dobber. in both situations, only turn to NAV when ALIGN flashes in the HUD 1 [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
WHOGX5 Posted February 23, 2021 Share Posted February 23, 2021 Also make sure you're not rearming while aligning as that will rock the aircraft and mess up the entire process. 1 -Col. Russ Everts opinion on surface-to-air missiles: "It makes you feel a little better if it's coming for one of your buddies. However, if it's coming for you, it doesn't make you feel too good, but it does rearrange your priorities." DCS Wishlist: MC-130E Combat Talon | F/A-18F Lot 26 | HH-60G Pave Hawk | E-2 Hawkeye/C-2 Greyhound | EA-6A/B Prowler | J-35F2/J Draken | RA-5C Vigilante Link to comment Share on other sites More sharing options...
Recommended Posts