investigating Pressing ATFLIR SETUP OSB before the pod is on stops the laser codes showing

[mrprime]

To reproduce this bug, 

 

1. Spawn a hornet
2. Add an ATFLIR
3. Put the FLIR in stand-by
4. Take off
5. Put FLIR on right DDI
6. Press 'SETUP' (RIGHT MDI PB 15)
7. Put FLIR to 'On'
   > Wait for the pod to come online
8. Once the pod's online, there's no option on 'RIGHT MDI PB 14' - this should be the laser code's / UFC text (note, pressing the button DOES still allow you to set the laser codes on the UFC, it's just the text doesn't appear)

 

Attached short track and screenshot showing that although the UFC text is missing, it is still possible to set the code via UFC

No laser OSB.trk

[BIGNEWY]

Sorry to be a pain, I am unable to reproduce and your track has the A4 mod which can not be used in our dev build. 

 

Could you repeat the issue for me on a clean mission,

 

thank you

 

[mrprime]

Doh! sorry about that, attached a fresh track with vanilla setup that shows the issue.

 

I went through enabling master arm, A/G mode, turning on the laser etc - but could not get the DDI text to appear if I mess with the SETUP page prior to the pod fully powering up.

ATFLIR osb missing.trk

[BIGNEWY]

Hi

 

thanks for the track, I can see you have issues in the track, but I can not reproduce in a clean mission. 

 

are you using any unofficial mods or edits? 

 

can I ask you to remove any unofficial mods if any and run a full cleanup and slow repair or verify if steam

 

please let me know if this helps or not. 

 

thank you

[mrprime]

No prob, I have the A4E mod and a counter measure program mod, I moved both out and ran a slow repair.

 

I tried again and still get the same behaviour - very strange!

 

Happy to try anything else you can recommend, otherwise it's easy enough to avoid by just not going to setup prior to the pod being fully on for me.