Jump to content

Recommended Posts

Posted

Hi I bought the virpil warbrd base to be combined with the warthog joy but I have no connection between them. Do you need to install the virpil software? Given that I removedthe two screws of the base and tried again on the warthog base and everything works

Posted (edited)

Yes, you need to instal the Virpil software and "tell" the WarBrd base you are using a Warthog stick

 

image.png

Edited by zildac

14900KS | Maximus Hero Z690 | ASUS 4090 TUF OC | 64GB DDR5 6600 | DCS on 2TB NVMe | WarBRD+Warthog Stick | CM3 | TM TPR's | Varjo Aero

Posted

Once this is done, no need for the Virpil software again.

Win11 Pro 64-bit, Ryzen 5800X3D, Corsair H115i, Gigabyte X570S UD, EVGA 3080Ti XC3 Ultra 12GB, 64 GB DDR4 G.Skill 3600. Monitors: LG 27GL850-B27 2560x1440 + Samsung SyncMaster 2443 1920x1200, HOTAS: Warthog with Virpil WarBRD base, MFG Crosswind pedals, TrackIR4, Rift-S, Elgato Streamdeck XL.

Personal Wish List: A6 Intruder, Vietnam theater, decent ATC module, better VR performance!

Posted

 

11 minutes ago, rob s said:

Thanks solved

Excellent, as @Lange_666 said no real need for the SW after this, however you may find it useful to keep it installed in case of a recalibration. Also note that by default the trim hat requires multiple pushes to operate as opposed to just holding. You can change this behaviour if you wish, as outlined in the post below:

 

 

14900KS | Maximus Hero Z690 | ASUS 4090 TUF OC | 64GB DDR5 6600 | DCS on 2TB NVMe | WarBRD+Warthog Stick | CM3 | TM TPR's | Varjo Aero

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...