fixed AACQ rejection

[Ahmed]

Hi, currently the only ways to exit AACQ is via selecting gun or A/G MM. This is correct but it is missing the third criteria of AACQ rejection. It should also exit AACQ if rejected via NWS (RWS/VS only) or TDC depress (all).

 

Track attached and PM inbound

aacq_reject.trk

Edited October 2, 2021 by Ahmed

[maxTRX]

Currently I can also reject it by switching TDC priority to another DDI and then back to ATTK. I normally switch to azel on LDDI then back to RDDI but like you said, pinky should also be an option.

[Jak525]

Pretty sure that NWS should exit AACQ in TWS as well. I believe that is a very old thing from a very old software (pre MSI) where the L&S target undesignate stepping was only applicable to TWS. In later loads though it should work to reject AACQ in any mode (since undesignate steps in both RWS and TWS anyway). Paging friendly neighborhood @Mo410 to double check

Edited October 4, 2021 by Jak525

[Mo410]

Undes/NWS should cancel AACQ - I don't think I have every used AACQ in TWS, so probably the same deal.  Also going through Boresight should cancel it as well.

[BIGNEWY]

I have made a report for the team.

 

thanks