CrimsonGhost Posted October 11, 2021 Share Posted October 11, 2021 Hello all. I wasnt really sure where to pose this question and I figured with the amount of TM Warthog owners that play DCS, this seemed like a logical place. I have been using the TM Warthog as my go to HOTAS for a number of years now, with the throttle mounted to a Monstertech desk mount that stays in place when not in use as it is not in my way. All of my flightsim gear and other USB hardware are plugged into a powered USB 3.0 hub under my desk and nothing gets unplugged in between uses. Last week, my computer was making the normal Windows sound that is made when a device is unplugged and plugged back in, rather frequently throughout the day. Nothing appeared to be changing, and the LEDs on the throttle remained illuminated. The following day when I turned my PC on, I noticed the LEDs on the throttle were off and sure enough, it was not showing up in the Windows settings nor in DCS. I began troubleshooting by swapping out the USB hub for a known good device which did not help, no matter what port I tried it on. My next step was to plug the throttle directly into my PC and when doing this, it is detected and works fine. Unfortunately this is not a permanent solution as the PC is too far away for the cord to reach. I ordered a couple of USB extension cables to see if this would rectify the issue, but it does not. So now I am stumped. If I plug in the throttle to the front panel ports on my case, it works fine, but any other connection method only leads to the LEDs flickering a few times and the throttle is not recognized. If anyone has any suggestions or ideas, I am all ears and would greatly appreciate it. I am reasonably hardware savvy and build all my own PCs, but the functionality of USB is not something I am all that familiar with. Thanks and I look forward to some feedback. i7-7700K @ 5.2Ghz SLI 1080Ti 64GB GSkill Trident Z RGB 4133 Asus Maximus IX Extreme Custom Water Cooling Loop TM Warthog/ MFG Crosswind Link to comment Share on other sites More sharing options...
Supmua Posted October 27, 2021 Share Posted October 27, 2021 (edited) Try a non-powered USB hub (like a 3-4 way hub). If that doesn’t work the only option would be logic board replacement. The last time I had to do that (logic board) was a few years back. There is also a guy on eBay that would fix the logic board if you don’t want to deal with TM tech support. Edit: I managed to fried my TMW logic board again somehow. The cost for a new board is $47 via Thrustmaster support. Edited October 30, 2021 by Supmua PC: 5800X3D/4090, 11700K/3090, 9900K/2080Ti. Joystick bases: TMW, VPC WarBRD, MT50CM2, VKB GFII, FSSB R3L Joystick grips: TM (Warthog, F/A-18C), Realsimulator (F-16SGRH, F-18CGRH), VKB (Kosmosima LH, MCG, MCG Pro), VPC MongoosT50-CM2 Throttles: TMW, Winwing Super Taurus, Logitech Throttle Quadrant, Realsimulator Throttle (soon) VR: HTC Vive/Pro, Oculus Rift/Quest 2, Valve Index, Varjo Aero, https://forum.dcs.world/topic/300065-varjo-aero-general-guide-for-new-owners/ Link to comment Share on other sites More sharing options...
Recommended Posts