Jump to content

RB-15F - how to investigate reason of inabliity to launch missile?


Recommended Posts

Posted

Hello,

The problem/question is as in the subject: how to determine, what is the reason causing inability to launch the RB-15F?
Does the mode selector, weapon selector, Bx waypoints have to be set in some specific sequence? The cardridge not in the slot can cause such problem?

 

Natural Born Kamikaze

-------------------------

AMD Ryzen 5 3600, AMD Fatal1ty B450 Gaming K4, AMD Radeon RX 5700 XT, 32 GB RAM Corsair Vengeance LPX, PSU Modecom Volcano 750W, Virpil Constellation Alpha Prime on Moza AB9 base, Virpil MongoosT-50CM3 Throttle, Turtle Beach VelocityOne Rudder.

Posted (edited)

Common issues are: 

  • out of altitude range for launch
  • Bx6 or Bx7 are behind you or out of sequence
  • Bx9 is too close to Bx8. Needs to be at least 30 sec flight time or something.  If you move Bx8 you might have to also move Bx9.
  • Bx7 turn angle is too tight. 
Edited by Machalot
  • Like 1

"Subsonic is below Mach 1, supersonic is up to Mach 5. Above Mach 5 is hypersonic. And reentry from space, well, that's like Mach a lot."

Posted (edited)

Thank You @Machalot.

So the sequence of "switchology" has no meaning for it?

EDIT:
All right, it seems that the Bx9 was too close to Bx8 in my case. Thank You @Machalot for hint!

 

Edited by Amarok_73
  • Like 1

Natural Born Kamikaze

-------------------------

AMD Ryzen 5 3600, AMD Fatal1ty B450 Gaming K4, AMD Radeon RX 5700 XT, 32 GB RAM Corsair Vengeance LPX, PSU Modecom Volcano 750W, Virpil Constellation Alpha Prime on Moza AB9 base, Virpil MongoosT-50CM3 Throttle, Turtle Beach VelocityOne Rudder.

Posted

Weapon mode must be ATTACK.

Master mode can be NAV, ANF, or (I think) SPA.

Trigger UNSAFE.  

I would recommend setting the switches in that sequence. I have problems sometimes if I UNSAFE first and then switch the master mode. 

  • Like 1

"Subsonic is below Mach 1, supersonic is up to Mach 5. Above Mach 5 is hypersonic. And reentry from space, well, that's like Mach a lot."

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...