stop a land unit on waypoints for a few seconds before continuing

[Facocero]

Hi guys.
I ran into a small problem, for which I could not find a valid solution.
I have an AI ground unit, it must travel through 5 waypoints already set. The first waypont is inside a trigger. I would like it to stop for about 20 seconds at the first waypoint and then continue on its own. Using the HOLD function in Advanced Waypoint Action It seems that setting a few seconds does not work, but only at the time set by default, see attached screens.
The first screens is the time that the editor suggests to me and it works, after the stop at 08.15.04 it starts again. if I set lower times it doesn't work.

[toutenglisse]

5 minutes ago, Facocero said:

...I would like it to stop for about 20 seconds at the first waypoint and then continue on its own...

Untick 'TIME MORE', and Tick "DUR" and set the duration you want (default is 15 minutes in your screenshot).

[Facocero]

I purposely left the time suggested by the editor. And in fact it works. But I need it to stop playing for about ten seconds and it doesn't work. Even Unchecking the Time More and enabling Dur, it doesn't work, unless I leave 15 minutes as suggested for Dur as well

[toutenglisse]

42 minutes ago, Facocero said:

I purposely left the time suggested by the editor. And in fact it works. But I need it to stop playing for about ten seconds and it doesn't work. Even Unchecking the Time More and enabling Dur, it doesn't work, unless I leave 15 minutes as suggested for Dur as well

It works for me - see axample attached (soldiers hold 30 sec at wpt1 then proceed to wpt 2). Maybe something else is wrong on your side (test with some duration as just stopping in formation takes time ...)

test-hold-pos-for-duration.miz

[Facocero]

Thanks and sorry if I wasted your time.
It works for me too now, I was the one who made a mistake in entering the seconds in the right field