In-cockpit sounds not working after last update.

[vCSG3 Palehorse 111]

I can't hear Jester, the RWR, or sidewinder tones since the last update.  Have run a repair with no results.  No mods.  Any idea how to fix this issue?

[draconus]

DCS > options > audio > headphones source and vol

Pilot cockpit:  power on, ICS hot mic, ICS and ALR-67/SW vol rotaries to max

http://www.heatblur.se/F-14Manual/general.html#pilot-volume-tacan-command-panel

Obviously Jester must be enabled and alive to be heard, SW must be onboard and selected, SW COOL on, RWR needs sources

DCS repair and clean

DCS new profile

Edited May 13, 2022 by draconus

[vCSG3 Palehorse 111]

I should also add that I can interact with the ground crew but cannot hear their responses, either.  I understand how to operate these components and have had no problems prior to the most recent update.  When flying with a human RIO I can hear the RWR going off through his mic but not in the pilot pit.  All of these functions work, but the audio is not audible.

[Egri_komrade]

I didn't encounter these, but half of the time when I flick a switch they make no noise, like every second use of a switch. Very annoying

[vCSG3 Palehorse 111]

Well, apparently there are two separate channels for audio in the settings menu and RWR, Jester, and ground crew are through the "headphones" channel, which was set to the wrong input.  So if you have this same problem, check that.  I didn't know this was a thing, so took a while to get it straightened out.  Hopefully this info will help others who may find themselves with the same issue.

[IronMike]

17 hours ago, vCSG3 Palehorse 111 said:

Well, apparently there are two separate channels for audio in the settings menu and RWR, Jester, and ground crew are through the "headphones" channel, which was set to the wrong input.  So if you have this same problem, check that.  I didn't know this was a thing, so took a while to get it straightened out.  Hopefully this info will help others who may find themselves with the same issue.

Thank you for sharing your solution!