fixed The Engine limits Count-Down Timers on ENG and FLT page are not reset in order as power is reduced

[Akiazusa]

Hi,it's just another small detail.

Issue: 

The Engine limits Count-Down Timers on ENG and FLT page are not reset in order as power is reduced.

 

 Expect:

After the engine reach a higher limit,the timer for lower limit will still be counting in the background.

As power is reduced from the higher limit to a lower limit,the timers for higher limit should be reset and replaced by the timers for lower limit.

 

Evidence:TM 251-10-----2.48.4 Count-Down Timers------NOTE

 

 

Here is the track：The Engine limits Count-Down Timers on ENG and FLT page are not reset in order as power is reduced.trk

 

For example ,in the track:

(Athough it applies to all timers but there are too many timers showed up in the track,please focus on the TGT one,and start from the second time when the TGT tape enters the yellow zone )

    First the engine TGT reached 810℃,a 30 mins timer (timer 1) started counting down, then the engine TGT reached 870℃,a 10 mins timer (timer 2) started counting down and replaced the timer 1.

    Then after the engine TGT was lowered to a value lower than 870 but higher than 810℃, the timer 2 was still displayed on the MPD and didn't be reset until TGT is lowered below 810℃.

    In this situation,the timer 1,which keeps counting in the background should pop up and replace the timer 2

 

 

(For FLT page the timer itself won't be showed but it will affect whether the TGT value is displayed on it.)

 

Much appreciate.

The Engine limits Count-Down Timers on ENG and FLT page are not reset in order as power is reduced.trk

Edited June 16, 2022 by Akiazusa