SantasGolfClub Posted June 30, 2022 Posted June 30, 2022 I'm trying to use two leavers to operate the power levers, but cannot seem to find anything that works. I'm able to go from Off to Idle, which is from full off, to the first detent on the controller. but cannot then find a way to go from idle to full power. I there a way to get the Honeycomb throttle quadrant to work with the AH-64?
Sacarino111 Posted August 17, 2022 Posted August 17, 2022 On 6/30/2022 at 1:56 PM, SantasGolfClub said: I'm trying to use two leavers to operate the power levers, but cannot seem to find anything that works. I'm able to go from Off to Idle, which is from full off, to the first detent on the controller. but cannot then find a way to go from idle to full power. I there a way to get the Honeycomb throttle quadrant to work with the AH-64? Hi. I bound both levers to one single axle (in setup/controlers and axles) and it works perfectly, only for both of them at the same time (obviously). Can't tell for them separated, but it should work also ok... I'll try later and bind the lever to a single one and I'll report back with the result. Saludos. Saca111
Recommended Posts