[FIXED] CM-802 AKG losing signal in mid/end course

[felipexlr50]

So before the update DCS 2.7.16.27869, the AKG was working fine on my missions.
But after the update I notice the AKG was losing the signal in mid/end course.

I tested on a empty Caucasus map mission with few targets at 70nm, and the AKG is almost the time losing the signal.

 

test akg.trk dcs.log

Edited July 22, 2022 by uboats

[uboats]

it's known issue and fixed internally

walkaround solution: turn 180 after launch

Edited July 22, 2022 by uboats

[Colmillo]

I tried the 180 solution, I did some tests and turning 60 degrees is enough to resume the link.
But I noticed that when trying to fire the second missile (in the same DIR function that I launched the first one) changes to RDY, and I can't fire it until I'm at 17 NM. Additionally, the horizontal line of maximum shooting distance appears in the HSD (as if it were LD6)

I tried everything, mode changes, function changes, etc. and it is not solved.

EDIT: SOLVED, PARAMETERS ERROR

Edited July 27, 2022 by Colmillo

[Napillo]

6 hours ago, Colmillo said:

changes to RDY, and I can't fire it until I'm at 17 NM.

You have to be in the right parameters for the release - relatively level flight, specific speed and altitude ranges as well.

[Colmillo]

Thanks @Napillo
 

I've just found this: 

Allowable Launch Altitude 1600 ft to 24600 ft Allowable Launch Speed Less than Mach 0.9

Probably with the second 802 I lose those parameters.

But..., I found that if I zoom (WIDE on HSD) I can't control the missile, I must change to NARROW (NAR ON HSD), Is that a bug?? (SOI on Right, of course)
 

Thanks