Avernus Posted July 29, 2022 Posted July 29, 2022 Since the later versions of DCS, George has been zooming the Tads out after the initial zoomed in scan, making it a lot more difficult to VID when watching the tads as we cycle the target list. I'm not sure if there are any features planned for control over these particulars, but it would be nice to have this behavour reverted until we can get george to to stuff. Thanks.
S. Low Posted July 29, 2022 Posted July 29, 2022 You can tell George to set zoom by highlighting a target and doing a long up or down press on the ai wheel. i don’t know if you can command him to change zooms after you select the target.
ED Team Raptor9 Posted July 29, 2022 ED Team Posted July 29, 2022 George will zoom in if necessary to ID the target. If you want to have him manually zoom back in while the target list is still displayed, you can use Up Long to zoom in or Down Long to zoom out. This only works if the target list is displayed. 5 Afterburners are for wussies...hang around the battlefield and dodge tracers like a man. DCS Rotor-Head
Ian Boys UK Posted July 29, 2022 Posted July 29, 2022 1 hour ago, Raptor9 said: George will zoom in if necessary to ID the target. If you want to have him manually zoom back in while the target list is still displayed, you can use Up Long to zoom in or Down Long to zoom out. This only works if the target list is displayed. Didn't know that. Thanks!
ED Team Raptor9 Posted July 29, 2022 ED Team Posted July 29, 2022 7 minutes ago, Ian Boys UK said: Didn't know that. Thanks! Brand new feature for the AH-64D that came out last week with the new George/Petrovich IFF functions. 1 Afterburners are for wussies...hang around the battlefield and dodge tracers like a man. DCS Rotor-Head
Recommended Posts