giullep Posted August 8, 2022 Posted August 8, 2022 To nav to homeplate i put on hsi the course of the airport… to now the landing direction. But on the ded in the ils page… what is needed the course setting?
AlexCaboose Posted August 8, 2022 Posted August 8, 2022 The magnetic heading of the runway with ILS active. 476th vFG Website, 476th vFG Discord, 476th vFG Pipeline
giullep Posted August 8, 2022 Author Posted August 8, 2022 THX..but in the detail how use it...is to activate the ils?
Frederf Posted August 8, 2022 Posted August 8, 2022 To use ILS: Ensure AUDIO2 > ILS volume knob is not at the minimum (off) position T-ILS DED page > ILS frequency enter digits and ENTR T-ILS DED page > Position asterisks with DCS to line five, enter localizer inbound course digits and ENTR Set HSI CRS knob to localizer inbound course if desired for normal HSI indication Set HSI mode with 'M' button to PLS/TACAN or PLS/NAV to enable ILS indications The CRS knob on the HSI affects only the HSI. The CRS setting on the T-ILS DED page affects only the ILS steering cue commands and heading tape wind caret. Normally HSI CRS and ILS CRS are set the same when using ILS but you don't have to. Part of ILS procedure may use HSI for other things like TACAN course. Setting HSI course knob will not change the HUD display. Example of where to find ILS frequency (green) and localizer inbound course (red) looking at an ILS approach chart
Recommended Posts