WSXMAX Posted October 24, 2022 Share Posted October 24, 2022 While you are using the CBU100s(103, 105, etc.,) and the target is in range. Press the "Weapon Release Button" and release it immediately. Make the weapon fail to release. The aircraft will show a message which said weapon release aborted. Few seconds later the status of CBU100s on the DSMS page will turn to "Aborted". So how to remove the "Aborted" status from the CBU100s? Link to comment Share on other sites More sharing options...
Aero4000 Posted October 24, 2022 Share Posted October 24, 2022 (edited) You can "reload" particular store station. A-10C2 manual pp 290-291. Clear Hung Station. This is a common error when the pilot does not hold down the weapon release button long enough when dropping a bomb. This warning and ability to use the weapon is resolved by reloading the hung station. This is done by: 1. Press DSMS INV (OSB 5) 2. Press the OSB (1 - 11) that corresponds to the hung station. 3. Press the OSB that corresponds to the store class of the hung weapon. 4. Press the OSB that corresponds to the type of hung weapon. 5. On the store page, press LOAD (OSB 9) to reload the station. 6. Press STAT (OSB 1) to return to the main DSMS page. Note: After clearing a hung IAM loaded store, you will then need to reset the power to the station in the STAT page and then reload ALL from the DTS page to make the weapon functional again. Edited October 24, 2022 by Aero4000 1 Спойлер 13700F, 64Gb DDR5 6000 MHz, RTX4080 16Gb, 27’ QHD 75 Гц FreeSync; Windows 11; VKB STECS Max HOTAS, VKB Gunfighter MK IV+ MCG Ultimate; VKB TRudder pedals MK V; VKB UCM Stronghold holders; Wireless TrackIR. Link to comment Share on other sites More sharing options...
HeXa4yPa6oTaTb(Юрий) Posted November 21, 2022 Share Posted November 21, 2022 It's easier to reboot SISU. Link to comment Share on other sites More sharing options...
Recommended Posts