Shutdown training mission not commencing after inserting ejection seat safety pin

[gulredrel]

Hello,

could someone please check the landing and shutdown training mission?

Tried this the second time and it will not commence after inserting the ejection seat safety pin into the seat.

Marker will stay on the canopy rail, where the pin was stowed during flight. Putting pin back up and insert again or pressing spacebar will not continue the procedure.

Thanks, screenshot an track attached below.

 

track: MB339-Landing-and-Shutdown-Training.miz_30102022_10-32.zip

 

edit:

I think I found the solutions, the next trigger contains a condition, which will not be met. I removed this condition marked in red and mission continued successfully.

Edited October 30, 2022 by gulredrel
possible solution added

[gulredrel]

@6S.Duke Thread should be moved to missions and campaign section, just realized that there is one.

Thanks

Jens

[Gianky]

Thank you @gulredrel!

I finally got to fly the 339 and I was stuck at that very same point, now I know how to go forward!

Edited November 21, 2022 by Gianky
Typo correction