Take off hot on runway, starts to shake and engine shuts down.

[Snuten]

Hi,

I have tried to fly both versions by putting the planes "Hot on runway" in a mission. But I can't take off. It just starts to shake then shuts off the engine. I also tried a cold start from the "Lessons" and it worked. But when adding the plane into my mission(on PG) I follow the procedure with start up (and also tried the assistant). But the same thing. When standing on the runway spooling up, releasing the brakes it take about 3-5 seconds and it starts to shake and shuts down.. No Parking brakes on, no Air brake down, flaps at take off, all pins removed. What wrong with this plane? Do I need to hold down Ctrl+Shift or something to take off?

Or what am I missing? Following the tutorial. Or is it because of PG map?

Edited November 4, 2022 by Snuten

[razo+r]

What's the weather like where you placed the aircraft?

[Snuten]

It is 24 degrees celsius and slightly rainy. (just checked in the ME overall weather)

Edited November 4, 2022 by Snuten

[Automan]

@Snuten
With wet runways you should always keep pushed relight button on your throttle.

Page 145 of the Flight Manual (included in Docs)
Take-off from wet runways
Take-off from wet runways may result in compressor stalls or flame out due to ingestion of water splashed by the nose wheel into air intakes. To prevent such occurrences, following precautions should be taken:
-Taxi at the lowest possible speed, avoiding puddles and water-covered areas.
-During the take-off run and until lift-off, hold the “RELIGHT” push-button pressed.
-Lift the nose wheel from the ground as soon as possible.

Edited November 4, 2022 by Automan
Tag

[Snuten]

Aha, sorry did't read the manual that closely. I will give it a try. Sounds like the problem. Lets hope it's not too rainy in Italy though   Thanks!

[Snuten]

That did the trick. Even though it didn't rain heavy. Thanks