Nialfb Posted March 24, 2023 Posted March 24, 2023 (edited) An issue with Auto Hover has recently occured on my Ka-50 III Black Shark. It has worked fine up until now, and I know how it works, but recently it has stopped working. I have tried the following ... Carried out a repair on DCS World beta Uninstalled the Ka-50 III module and deleted the MOD folder from the Eagle Dynamics parent folder. Rebooted my PC and reinstalled the Ka-50 III module and carried out a repair again on the beta. Created a new mission with two Ka-50 III - one hot start, one cold start. I noticed that after reinstalling the Ka-50 III the Auto Hover light came on momentarily when activated in the mission but went off almost immediately and has not functioned since. It makes no difference if I use the hot start or cold start versions. I can put the Ka-50 III into a hover manually and all functions of the auto pilot work correctly. I changed the binding on my Hotas and also the default keyboard key press but it made no difference. I changed the keyboard binding back to LALT-T I think I noticed that the auto hover stopped working after I had made changes to the INS Alignment in one of my existing missions via the mission editor. I changed the INS Alignment to 'Fully realistic' in the 'Realism panel' and 'Normal with Gyro' in the 'At Hot Start Panel'. I have since changed back to 'No alignment or fixtaking needed' to test the system but it makes no difference - the Auto Hover still refuses to work. This is infuriating, and although I can put the Ka-50 III into a hover for the missions it is infinitely easier with the Auto Hover button working. HELP! Thanks BTW ... I am on version 2.8.3.38080 Edited March 24, 2023 by Nialfb Game setup - I9-13900K, 3000 MHz 24 Core 32 Logical Processors, NVIDIA RTX 4090, 42” ASUS 4K OLED monitor, TM HOTAS Warthog, TM TPR Rudder pedals, Bigscreen Beyond VR.
Solution Nialfb Posted March 26, 2023 Author Solution Posted March 26, 2023 FIXED! Here is what I did. I made a backup of my control settings - throttle, jopystick and rudder. I then set the controls for my throttle (this is where I have the binding for auto hover) back to the default controls. I tested the auto hover and it workedI I went back to controls and updated the controls using my backup I had taken earlier and it all works fine again! 1 Game setup - I9-13900K, 3000 MHz 24 Core 32 Logical Processors, NVIDIA RTX 4090, 42” ASUS 4K OLED monitor, TM HOTAS Warthog, TM TPR Rudder pedals, Bigscreen Beyond VR.
Recommended Posts