Sparviero1978 Posted April 5, 2023 Posted April 5, 2023 (edited) Hi, I got 8+8 GB 3000 RAM ddr4 and I recently purchased 16+16 GB 3200 RAM ddr4 (same manufacturer, basically very similar sticks). I put the new 16+16 in the main channel of my motherboard, but what about the old one? Should I put them in the second channel or not? I read that more than 40 GB of RAM are used by Dcs in some situations, but I'm worried about system instability/ worse performance of this mix. Any suggestions? Thanks. Edited April 5, 2023 by Sparviero1978
Mr_sukebe Posted April 5, 2023 Posted April 5, 2023 Give it a try with them in. The worst case scenario is that it doesn’t work and you pull them out. 7800x3d, 5080, 64GB, PCIE5 SSD - Oculus Pro - Moza (AB9), Virpil (Alpha, CM3, CM1 and CM2), WW (TOP and CP), TM (MFDs, Pendular Rudder), Tek Creations (F18 panel), Total Controls (Apache MFD), Jetseat
BitMaster Posted April 5, 2023 Posted April 5, 2023 (edited) They will likely be all set to 3000. two days ago I did Observer on a busy server, lots of F2 and F10 … and my RAM kept climbing while hopping scenes with F2. I had a top usage of 40GB DCS in TaskManager and 60GB in use in MSI Afterburner .. wow. it was all very smooth and no delays anywhere. Yes, it loves RAM Edited April 5, 2023 by BitMaster Gigabyte Aorus X570S Master - Ryzen 5900X - Gskill 64GB 3200/CL14@3600/CL14 - Sapphire Nitro+ 7800XT - 4x Samsung 980Pro 1TB - 1x Samsung 870 Evo 1TB - 1x SanDisc 120GB SSD - Heatkiller IV - MoRa3-360LT@9x120mm Noctua F12 - Corsair AXi-1200 - TiR5-Pro - Warthog Hotas - Saitek Combat Pedals - Asus XG27ACG QHD 180Hz - Corsair K70 RGB Pro - Win11 Pro/Linux - Phanteks Evolv-X
Recommended Posts