AndreNL Posted May 24, 2023 Posted May 24, 2023 Dear, After a busy period on the farm (I'm a farmer) I finally had time to pick up the thread again with the AH64. But I see quite a few problems in the meantime. After playing for 30 minutes I come to the following conclusion: 1 I cannot switch between radio presets with the swap button. 2 In the cpg position (also as pilot): the tads goes crazy. It's doing some zigzag pattern continuous which I can't turn off. 3 Laser designator does not work, I cannot turn it on. Not that it matters since the tads keep zigzagging. 4 There are apparently Longbow missles now, cool!. But I can't select RF as a pilot in the weapon page. Tried in MT and without MT. I haven't taken/had the time yet to scour the entire forum for these issues.
Solution JSpidey Posted May 24, 2023 Solution Posted May 24, 2023 (edited) 1. Swapping radio presets is WIP atm, the devs are aware of the issue. 2. On a cold start George likes starting with the LST/LT (Laser Tracker) switch to A (AUTO), you can hop in the front seat and turn it to O (OFF), it's on the right handgrip. 3. The laser will not fire when the LT switch is in AUTO mode, turning it off will allow you to fire the laser. 4. You can't select RF missiles as the pilot, only the CPG can until we get the FCR Also the zigzag patterns you're seeing is the Laser Spot Tracker doing a 3 bar scan for any laser spots. Edited May 24, 2023 by JSpidey
AndreNL Posted May 24, 2023 Author Posted May 24, 2023 54 minutes ago, JSpidey said: 1. Swapping radio presets is WIP atm, the devs are aware of the issue. 2. On a cold start George likes starting with the LST/LT (Laser Tracker) switch to A (AUTO), you can hop in the front seat and turn it to O (OFF), it's on the right handgrip. 3. The laser will not fire when the LT switch is in AUTO mode, turning it off will allow you to fire the laser. 4. You can't select RF missiles as the pilot, only the CPG can until we get the FCR Also the zigzag patterns you're seeing is the Laser Spot Tracker doing a 3 bar scan for any laser spots. Thank you for your comment, I really appreciate it! I gonna check the right handgrip for the on/off LST. 1
Recommended Posts