Game locks up when trying to change a control in UI layer

[Varry007]

I started the game with VR disabled (to be able to record).

I start the game in single thread; when trying to change the VR zoom setting, the game starts loading all profiles, and gets stuck at KA50, and the game is then locked, need to CTRL-alt-del to close the game.

 

I already did a full repair. Is is the same in MT, with or without VR.

 

 

 

 

Edited November 7, 2023 by Varry007

[Flappie]

Hi. Try this:

1. Browse to "Saved Games\DCS...\Config\Input".
2. Add a ".bak" suffix to your "ka-50" and/or "Ka-50 III" folder(s) so DCS cannot find them.
3. Run DCS and retry to assign a control to VR zoom setting. This time, it should work.
4. Zip your Ka-50 folder(s) and attach them here, I'll see if something is broken in them.

[Varry007]

On 11/7/2023 at 11:36 PM, Flappie said:

Hi. Try this:

1. Browse to "Saved Games\DCS...\Config\Input".
2. Add a ".bak" suffix to your "ka-50" and/or "Ka-50 III" folder(s) so DCS cannot find them.
3. Run DCS and retry to assign a control to VR zoom setting. This time, it should work.
4. Zip your Ka-50 folder(s) and attach them here, I'll see if something is broken in them.

Hi @Flappie: thank you so much. Problem is solved. I had some backing up software syncing to my nas (backing up my DCS saved games) which was stuck on syncing the KA-50 profile, and reserved acces to the file.

Thanks again for helping me!

[Flappie]

Your feedback is appreciated. I'm sure it will help others with the same issue. Thank you.