Trimmer modes broken?

[Falconeer]

Hello,

i recently got in the BS III again and noticed that the controls were quite jerky after trimming. I went to the special tab and noticed it was in "Center Position" trimmer mode. For comparison, i changed it to "Instant Trimmer" and loaded up the same mission. to my feeling, there is no difference between the 2 at the moment.

Every time i set the trim and release my stick back to center, the AP still gives an extra input to the controls (especially on roll) making flying difficult and jerky

Anyone noticed this aswell?

 

 

center trim.trk default instant trim.trk

Edited November 19, 2023 by Falconeer

[Falconeer]

Noone have these issues?

[guriak]

Yes I am having a similar issue, I am constantly having to adjust trim and it feels like I'm fighting the aircraft most of the time. Auto turn to target does not work, I just start spinning. Makes doing any missions extra challenging 

[Vital061270]

For a smoother turn, I hold the trimmer down; turn to the desired heading: stabilise the machine in roll and pitch, and only then release the trimmer. The turn becomes coordinated and smooth. 

For more accurate point or target acquisition, the instrument navigation system exhibition procedure (accurate, normal or fast) should be performed before launching the helicopter. Otherwise, reaching the point and the flight itself will be unpredictable.

[guriak]

10 minutes ago, Vital061270 said:

For a smoother turn, I hold the trimmer down; turn to the desired heading: stabilise the machine in roll and pitch, and only then release the trimmer. The turn becomes coordinated and smooth. 

For more accurate point or target acquisition, the instrument navigation system exhibition procedure (accurate, normal or fast) should be performed before launching the helicopter. Otherwise, reaching the point and the flight itself will be unpredictable.

Thank you, I had just discovered this while playing around with it this morning. Instant trim setting while holding the trim button down until the aircraft is stabilized then releasing the trim button yielded good results. Cheers!

[Falconeer]

Well, the problem is that for me there is no noticable difference in trimmer modes in the special tab.

I get the same jerky motion with all the trimmer modes and that wasn't the case before. I know holding down the trimmer button during manouvring, but when i release the trimmer button and release the stick back to neutral, the aircraft still puts in extra motion, causing me needing to trim again.

It's like the aircraft is putting in extra trim over my trim, because my stick "was" in that position. And my stick setting is on "neutral stick trimmer", so i should have more time to release my stick back to center, but that is not happening and therefore i have a feeling that both trimmer settings in the special menu act the same and the tracks show it too

Happens in BS II and BS III

Edited November 23, 2023 by Falconeer

[Schlomo1933]

Make shure there is no FFB enabled in the option menu

[Falconeer]

I double checked and its off