Jump to content

Small project organization DCS-BIOS and FreeJoy


Bucic

Recommended Posts

Hi! 

I'm preparing to put together my very first simpit project. Any recommendations with regard to project organization?

 

Goals:

1. Small but DCS-BIOS-ready 

F-5E left console + weapons panel + fuel control panel

2. Low-cost. I don't mind extra soldering.

3. Organised into 4 modules at the beginning. The entire left console as one module.

4. Preference: buttons on flight controls managed by FreeJoy

 

References:

https://forum.dcs.world/topic/161441-generic-dcs-bios-panel

https://forum.dcs.world/topic/310930-maximising-the-use-of-arduino-nanos-max-switch-connections-possible/

https://github.com/dcs-bios/dcs-bios.github.io/blob/master/docs/v0.2.5/userguide.adoc#connecting-your-first-panel

 

EDIT:

Homing in...

https://www.reddit.com/r/hoggit/comments/1375vhv/home_cockpit_crew_dcs_bios_or_arduino_as_a_hid/

https://forum.dcs.world/topic/185244-cockpit-electronics-quotecosystemquot-selection/

https://forum.dcs.world/topic/118288-dcs-bios-discussion-thread/page/28/

! https://forums.mudspike.com/t/buttons-and-you-simple-and-cheap/2994

https://learn.sparkfun.com/tutorials/shift-registers

! https://electronics.stackexchange.com/questions/83720/a-good-circuit-for-a-large-number-of-push-button-inputs

!!! https://forum.dcs.world/topic/239192-dcs-bios-arduino-breakout-board/

https://forum.dcs.world/topic/142329-searching-for-an-volunteer-alfa-testing-new-dcs-bios-rs485-transmitters/

 

answer on shift registers from the main DCS-BIOS topic https://forum.dcs.world/topic/118289-dcs-bios-overview-and-announcements/?do=findComment&comment=5341306

 

 

DCS-BIOS RS-485 bus

https://forum.dcs.world/topic/118288-dcs-bios-discussion-thread/page/13/#comment-2752970

https://forum.dcs.world/topic/134918-dcs-bios-rs-485-and-hardware-related

https://forum.dcs.world/topic/118288-dcs-bios-discussion-thread/page/13/#comment-2752970

 


Edited by Bucic
Link to comment
Share on other sites

After reading some more I guess my question should be "How to use shift registers with DCS-BIOS?" Interestingly "shift register" is nowehre to be found in DCS-BIOS documentation. Neither is the information on discontinuation of the project and the new-new fork https://github.com/DCS-Skunkworks/dcs-bios

 

Link to comment
Share on other sites

On 12/2/2023 at 9:20 PM, Bucic said:

After reading some more I guess my question should be "How to use shift registers with DCS-BIOS?" Interestingly "shift register" is nowehre to be found in DCS-BIOS documentation. Neither is the information on discontinuation of the project and the new-new fork https://github.com/DCS-Skunkworks/dcs-bios

 

The Fork isn't "new,new" it's at least a few years old, and the Skunkworks name is a recent change.  It used to be called "Flightpanels Fork".  The name was changed because it had diversified from just creating an interface for Saitek Flight Panels to cover Stream Decks, Arduinos, and more recently, there's some work going on WRT WiFi-connected ESP32s.


Edited by No1sonuk
  • Like 1
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...