FCR - Symbology Declutter / Zoom

[Emme]

Hey there.

I was wondering if the FCR will have some sort of declutter or zoom function at one point? Not sure if I'm missing something on my end, but I find it very hard to tell how many returns in total the radar is showing due to the symbology being cluttered all together. How to tell how many targets there are when using the FCR?

Another thing I don't seem to understand fully, shouldn't the returns disappear after destroying a certain target? Actually I did not find a way to really tell what target has been engaged already due to the FCR cycling through already engaged targets. So it often happens that I'm shooting at the same target twice, while other targets stay completely ignored. (btw I know there's a little cross showing what target has been engaged, but that's often just completely impossible to read)

Thanks for any input.

 

Best regards.

Edited February 27, 2024 by Emme

[Tholozor]

47 minutes ago, Emme said:

Another thing I don't seem to understand fully, shouldn't the returns disappear after destroying a certain target? Actually I did not find a way to really tell what target has been engaged already due to the FCR cycling through already engaged targets.

The FCR cannot determine the difference between something that is alive versus something that is dead, as in either state it would look like roughly like the same thing.

Using the ATK Phase on the TSD, you can see your SHOT marks for Hellfires to determine which targets have already been engaged. However, it will be up to you to determine if the target was actually destroyed.

[Moxica]

Here's an "official" quote:

"The TSD can display more than 16 targets when set to the attack phase, but all low-priority target symbols will be displayed at half the size as the 16 high-priority target symbols.

The C-SCOPE and ZOOM functions on the FCR page are not currently implemented, nor is the LINK function on the Sight-Select switch. These will come later in early access, along with other radar modes."

I'm hoping the "ZOOM" function helps distingushing targets on FCR.

Edited February 27, 2024 by Moxica

[Floyd1212]

7 hours ago, Emme said:

How to tell how many targets there are when using the FCR?

The number of targets returned by the scan is displayed at the upper-right.  Hopefully the Zoom function will make distinguishing these targets on the FCR page much easier.

 

[Emme]

Thank you guys for the replies. Completely missed out on that top right corner box, but that does help a lot to clarify what's going on.

O7

[jubuttib]

Thanks for that top right box mention, I had no idea! Very helpful!