F-15EX grips on Super Taurus throttle

[VpR81]

Hi all,

i´m running the F-15EX throttle grips on the old Super Taurus throttle. After flying the Hornet and the Mudhen, i wanted to map my controls for the F-16 now and saw that the axis on the left grip handle doesen´t work. According to the WinWing homepage, it should very much on the ST throttle.

So went back into the SAP test panel and saw the buttons wich are said to not work on the ST are greyed out (as it should be), but the axis on the left throttle grip is highlighted. Still no joy here as well. Is this a limitation of the ST throttle wich isn´t listed on the WW homepage (wich would be unfortunate, as this axis was one of the reasons to get the grips)? Or do i have a faulty unit? Firmware is up to date on all three devices (Throttle base, start-up panel, throttle grips).

Cheers

[MustangSally]

The throttle axis is independent of the grips. I'd say you have connection issue inside the the Super Taurus if the left axis is totally greyed out

[VpR81]

Hi,

thanks for the answer, but i think my description was a bit inaccurate. The axis´ of the throttle base are perfectly fine. It´s the axis on the left handle (that large grey axis wheel - see pic) wich is not working. Neither in DCS, nor in SAP test panel or windows device manager. It´s highlighted in the SAP test panel, but does not registrate any input. According to the WW homepage, it should work on the ST throttle. Sorry for beeing unclear, my fault.

 

Edited March 20, 2024 by VpR81

[Nyteshayd]

I know it has been a while but anyone else who gets this issue, click over to the calibration tab in simapppro and click the Rz calibrate button. Then move the knob back and forth about 5 times and then center it before clicking done and it will work.

[Nightstorm]

Thank you.  I just installed this throttle tonight and had the same issue.  Calibration worked.