Flight control loss (Stick Only)

[Firebird1955]

I tried putting this in the bug channel but no responses or views so thought I would try here. 

 

Two recent flights on the Syria map (Multiplayer) I have had the stick completely disconnect from the flight controls.  While the throttle and other controls functioned as normal, the stick inputs were not transmitted to the aircraft.  When I open the control UI, on the axis page, the motion is detected  for all axis inputs (pitch and roll).  I had this happen two flights (same mission).  I assumed it was an internal issue within my controllers, but last night it happened to another client exactly the same, just flying and all of a sudden no stick inputs are recognized.  Also had axis commands showing within the control UI (Axis).  The other client was sling a RS FSSB and I use a transducer controlled stick as well, and both have curves set in the UI and the special page for the F-16 has the FSSB options (Both) on with limited Dead zone inputs.    Anyone else had this happen?  DCS didn't crash and you could escape and use any of selections on it.  Issue remained until you backed out of the server and reconnected.

[speed-of-heat]

make sure you haven't got power saving enabled on the USB device opr hub that supports 

[Firebird1955]

Thanks for the response.  We will check into it but with it happening to another person on the other side of the world exactly the same way, thought it might be something more common to both.  We are going to try again with a different mission and see if it happens again.  Also will check power as well as this is on a hub with other inputs