Sparrow-5 Posted January 10 Posted January 10 I'm having problems trimming the hornet in flight when it comes to trimming it on the roll axis, pitch axis works. I have tried Ctrr+ left/right arrow keys, Input for joystick etc. as well holding them down for a longer period in case the whole trimming happens slowly but without any result. The values on the FCS page changes when i put the input in but as soon as i let go of the trim the values resets to the values before i started to try and trim the aircrafts roll axis.
rob10 Posted January 10 Posted January 10 45 minutes ago, Sparrow-5 said: I'm having problems trimming the hornet in flight when it comes to trimming it on the roll axis, pitch axis works. I have tried Ctrr+ left/right arrow keys, Input for joystick etc. as well holding them down for a longer period in case the whole trimming happens slowly but without any result. The values on the FCS page changes when i put the input in but as soon as i let go of the trim the values resets to the values before i started to try and trim the aircrafts roll axis. If it's going back then likely you have a binding issue somewhere. How do have them bound? Check that you don't have a continuous input of a trim reset.
razo+r Posted January 10 Posted January 10 (edited) Also make sure simplified/arcade/game flight model is turned off in the options. Edited January 10 by razo+r
ED Team Lord Vader Posted January 10 ED Team Posted January 10 Hi @Sparrow-5 I just tested the trim for the roll axis and it seems ok. Like it was suggested, check your bindings. If you need help, post your binding for the trim hat switch so we can haver a look. Esquadra 701 - DCS Portugal - Discord
Recommended Posts