AH64D George AI Helper reverts to default everytime i restart DCS

[Renko]

AH64D George AI Helper reverts to default everytime i restart DCS.

I have in my HOTAS those commands only in my Stick, nothing mapped in my Throttle.
But everytime i start DCS my Throttle populates with commands.

I even forced DCS to make a Input folder from scratch and the same behaviour happens.

This issue its only related to the Apache. For example, this doesnt happens in the Hind.

I think when this section its empty DCS forces an uncommanded back to default keybind for my throttle.

Here is a screenshot
The highlighted area is the one doing the uncomanded default keybind.

[Renko]

Its just not me. Saw today another user saying this in ED's discord:
"Has it been reported yet that for some modules (in my case a10 c2), whenever I restart DCS, controller curves get reset? more specifically on my virpil cm3 throttle, both engines individually, curves get reset. Is there a workaround? Dont know if it's just me. Havent seen it on other modules.. "

[Renko]

Please can this be checked
At September 18 with the DCS version 2.9.20.15010, it still happens. Each single time DCS starts

And yesterday patch included a fix particulary to the same hardware that has this issue in other module.
The VPC Throttle MT-50CM3

null

[flanker0ne]

Is the Throttle always connected to the same USB port?

I need to know if the device keep the same CLSID 

[Renko]

59 minutes ago, flanker0ne said:

Is the Throttle always connected to the same USB port?

I need to know if the device keep the same CLSID 

First of all, thank you for answer this thread

Yes, same USB port for each device of the sim hardware always. It keeps the same ID so that way DCS keeps the keybinds
In the input folder (AH-64D_BLK_II_AI_Menu) there is no .diff.lua file asociated to the throttle for George AI, because i have no custom keybindsfor the throttle there

The situation does occur each time i start DCS.
Meaning samething happens if i start it tomorrow, or if i enter and exit seconds after reaching the control menu to clear those controls. Each single time it resets.

But as i said in May: 
I think when this section its empty DCS forces an uncommanded back to default keybind for my throttle.

If i make a custom keybind in that section of George AI even with one button on the Throttle, so a file is created in the input folder, the issue i have doesnt happens.
But if then i clear again that category and restart DCS, it will happen again. That Throttle section will be populated again with the default keybinds

I think its reverting for some reason to default. Its the only module where that issue happens.

Edited Thursday at 06:29 PM by Renko