flare2k17 Posted 9 hours ago Posted 9 hours ago When starting the 29 i usually don't use ground power but instead turn on my apu like in the mi 24. I've seen other people just using battery power to start up the whole plane. Does the apu have any effect on how the plane actually starts up?
AeriaGloria Posted 9 hours ago Posted 9 hours ago No, you’re fine. Black Shark Den Squadron Member: We are open to new recruits, click here to check us out or apply to join! https://blacksharkden.com
CrazyGman Posted 5 hours ago Posted 5 hours ago Speaking of startup. I tried flipping all the switches at once using the master lever that allows all switches to be flipped in one go, but my gyros' wouldn't align properly if I did that. When I did the procedure normally as per wags video everything worked fine, but I'm wondering why it then has that master lever to flip all the switches at once if that cause the startup to not work properly
Dača Posted 4 hours ago Posted 4 hours ago 58 minutes ago, CrazyGman said: Speaking of startup. I tried flipping all the switches at once using the master lever that allows all switches to be flipped in one go, but my gyros' wouldn't align properly if I did that. When I did the procedure normally as per wags video everything worked fine, but I'm wondering why it then has that master lever to flip all the switches at once if that cause the startup to not work properly 6 switches on electric panel ? I use the cage always and never had issues. Have you disabled main power switch for main gyro as Wags did in video tutorial? If you had, don't do that anymore. It creates gyro problem and INS alignment is busted. Instead use main - stby gyro mode on navigation panel to check if stand by gyro holds same heading.
CrazyGman Posted 1 hour ago Posted 1 hour ago 2 hours ago, Dača said: 6 switches on electric panel ? I use the cage always and never had issues. Have you disabled main power switch for main gyro as Wags did in video tutorial? If you had, don't do that anymore. It creates gyro problem and INS alignment is busted. Instead use main - stby gyro mode on navigation panel to check if stand by gyro holds same heading. No not that cage. The one on the bottom left that covers the gyros, radios, weapons IFF etcetera.
AhSoul Posted 1 hour ago Posted 1 hour ago 12 minutes ago, CrazyGman said: No not that cage. The one on the bottom left that covers the gyros, radios, weapons IFF etcetera. It's a good question. I've only used the normal procedure where you toggle them as needed, and wondered why it had a cage to toggle them all too.... [sIGPIC][/sIGPIC] Soul's pit thread
Dača Posted 1 hour ago Posted 1 hour ago 4 minutes ago, CrazyGman said: No not that cage. The one on the bottom left that covers the gyros, radios, weapons IFF etcetera. It may be an issue to do that. Not sure if that is according to procedures. Never tried it myself. AFCS damper may also become issue if all 3 trimmers are not centered. But try again and wait for gyro to spin up 30-40 seconds. Do not disengage main gyro switch on this panel to test standby gyro ! Actually try not to touch anything. After 30-40 seconds on keyboard press J + 9 keys, both at the same time and hold for 1-2 seconds. Theoretically, it could work. In the end cage is used for reducing preparation time and only for emergency scramble to intercept upcoming threats. No need if you are "casual".
Recommended Posts