Problem with hoystick and fire button

[shackman]

Whenever I start a mission the joystick always seems a little too sensitive. I mean if I just tap the stick then the plane will start a slight turn to the left or right depending on the side i tapped it on. Is there a way to fix this so it isn't so sensitive? I've already recalibrated it.

 

And what is the button to fire weapons? I've assigned the weapons fire button, but whenever I press that and have an AIM-120 or 9 selected it only fires the cannon?:helpsmilie:

Edited July 11, 2010 by shackman

[Mugenjin]

you need to use the "release weapon" button for US planes to fire missiles/release bombs.

[combatace]

Make a mission with only one plane(high speed jet) and make it player flyable. Now run the mission and go full after burner and when you reach some 1300Kmph make high G turns rolls and use the rudders too, after than your stick will act normal and its hyper sensitivity will vanish.

[shackman]

Make a mission with only one plane(high speed jet) and make it player flyable. Now run the mission and go full after burner and when you reach some 1300Kmph make high G turns rolls and use the rudders too, after than your stick will act normal and its hyper sensitivity will vanish.

i tried doing that and it still there. can you post an acmi file of how hard to turn and roll or describe them?

 

and the trim is causing problems with the nose. when i start a mission the trim is way up and continues to cause problems such as coming out of a turn the nose drops down from where it was pointed. :(

Edited July 11, 2010 by shackman

[hassata]

In options/control/axis (ir whatever it is exactly) you can press on the x/y axis of the joystick and get a line graph. Adjust to your liking (e.g. flatten and increase deadzone to make less sensitive).

 

As stated above, assign button to release weapons, and remember you may have to keep it pressed for more than 2 seconds to release some weapons (e.g. the 120).

 

Enjoy the sim-it's amazing.

[Bearitall]

 

And what is the button to fire weapons? I've assigned the weapons fire button, but whenever I press that and have an AIM-120 or 9 selected it only fires the cannon?:helpsmilie:

 

Well, make sure you've selected either 2-4 number keys..also hit " D " that puts you in missle weapons selection mode..hitting " D " cycles you thru your weapons ... hitting " C " puts you in cannon mode...

 

To fire missle's I think its RALT+Space...:music_whistling:

[shackman]

Well thanks for the help i fixed the control issue. I hadn't changed the curvature of the axis. So that done but now when i launch weapons I can't fire the canon? Even after I'm in gunsight mode?