DTOT

[mr_mojo97]

Hi all, how do i set this in the cdu, ufc or mfcd? Thanks

[Rongor]

It doesnt matter where you edit waypoint data (like the DTOT).

- You can watch data in the CDUs own display or in the MFCD (on the CDU page)

- You can give inputs to the CDU via the UFC, the OSKs of the MFCD (if CDU page is displayed) or the CDUs own keypad.

- You can combine these inputs/displays to your own convenience...

[mr_mojo97]

Thanks, what i meant was though HOW do i set the dtot? Ta

[WildBillKelsoe]

When you view the WAYPOINT page for any waypoint, the DTOT field is on the right side. By using the CDU or UFC keypads you can enter the hour/minute/second (xx-xx-xx) that you want to reach the waypoint and then press the LSK to the right of the DTOT label. This will set the DTOT for that waypoint.

 

^^ manual, page 471/672.

 

For example, you are on Initial waypoint, next waypoint is MSN001. Set the waypoint with HUD and DMS up short. Then put CDU on MFCD, then on UFC, press FN then 3 then WAYPOINT then enter the clock time you want to be on target. (For instance it is 13:00:15 now - One o'clock and 15 seconds.) You want to be over MSN001 @ 14:20:35 - Twenty minutes past two o'clock and 35 seconds)

 

 

Input as follows:

 

1 4 2 0 3 5 |

 

then RSK next to DTOT field on the WAYPOINT page for that waypoint.

[mr_mojo97]

Superb, cheers for that info mate. Looked for it in the manual last night but couldn't find it. Got it now though