Jimbo Posted March 25, 2013 Posted March 25, 2013 Hi All, I've been re-wiring a Jay-El (type 10648 ) switch on my NMSP. In doing so, I've managed to pull one of the wires out of the back and cant see a way to disassemble the case to re-solder the wire back on. At least not without braking it. Anyone ever seen the inside of one of these things? Any pointers much appreciated. Jim
Deadman Posted March 25, 2013 Posted March 25, 2013 it is probably an IWTS connection http://www.google.com/patents/US4189204?printsec=drawing#v=onepage&q&f=false you would need the correct insertion an extraction tool . remove the pin remove the old solder or it may be crimped on in witch case uyou will ne a replacement pin fix replace with the installation tool and test https://forum.dcs.world/topic/133818-deadmans-cockpit-base-plans/#comment-133824 CNCs and Laser engravers are great but they can't do squat with out a precise set of plans.
Jimbo Posted March 25, 2013 Author Posted March 25, 2013 Thanks Deadman. I managed to find the install manual with pin out info on it. Back up and running :)
Deadman Posted March 25, 2013 Posted March 25, 2013 So what did you have to do just shove the wire back in ?:( Thanks Deadman. I managed to find the install manual with pin out info on it. Back up and running :) https://forum.dcs.world/topic/133818-deadmans-cockpit-base-plans/#comment-133824 CNCs and Laser engravers are great but they can't do squat with out a precise set of plans.
Jimbo Posted March 25, 2013 Author Posted March 25, 2013 I didnt say it was an elegant solution ;) I peeled back the rubber (I guess water resistant cap) and managed to expose enough of the old wire to solder the connection back on. Thankfully, the wire in question was top left, so I didnt have to damage it too much to find the relevant connection. I have the links to the manuals at work so will post tomorrow. Gives a pretty good schematic of whats going on inside the thing.
Deadman Posted March 25, 2013 Posted March 25, 2013 It works LOL and the seal is a PITA I have cut it off several switches to get thing working https://forum.dcs.world/topic/133818-deadmans-cockpit-base-plans/#comment-133824 CNCs and Laser engravers are great but they can't do squat with out a precise set of plans.
Recommended Posts