Mission Editor FARP - Unable to Comply

[Nybble]

Hi all,

 

I have built a mission that had a farp placed a while out from the starting airbase. When I flew over their and landed the FARP gave the 'Unable to comply' message when I requested refuel / rearm.

 

I set some choppers to ramp start there and they receive the same message. The FARP itself is set to have unlimited munitions and fuel. Is there somthing I am missing?

 

I can provide the mission file later if necessary.

 

Thanks!

[Nybble]

Found the fix.

 

I was placing static objects FARP Ammo and FARP Fuel, however for NATO units to resupply it appears you require the supply trucks.

[mwd2]

For BLUE add:

Transport M1025 HMMWV

3x Transport M818

Transport M978 HEMTT

Static FARP Tent

 

in a radius of 90m around the FARP position

 

For RED add:

CP SKP-11 Command or FARP Command Post

GPU APA-50 or GPU APA-80

ATMZ-5 or ATZ-10 or FARP Fuel Depot

Ural-375 or FARP Ammo Dump

UAZ-469 or FARP Tent

[shelt]

For BLUE add:

Transport M1025 HMMWV

3x Transport M818

Transport M978 HEMTT

Static FARP Tent

 

in a radius of 90m around the FARP position

 

For RED add:

CP SKP-11 Command or FARP Command Post

GPU APA-50 or GPU APA-80

ATMZ-5 or ATZ-10 or FARP Fuel Depot

Ural-375 or FARP Ammo Dump

UAZ-469 or FARP Tent

 

Thanks for the tip on the units required. Sure makes it easier to allow rearming.

I always assumed any unit was enough to allow resupply (like at an airbase) but guess this isn't the condition at a FARP

[ENO]

Ideally you'll dig up a template somewhere that has all required resources all properly configured- after awhile placing all that nonsense at multiple locations gets old.